
ServicesWhole-Home Filtration
Whole-Home Filtration in Lockhart
We install filtration where the water line enters your home, so every faucet, shower and appliance gets cleaner, better-tasting water. We start by testing what you actually have, then size a system to match it. Installation is free.
Filtered water at every tap, not just the kitchen
A whole-home system sits on your main line, usually near where the water enters your home in the garage, utility area or along an exterior wall. Treated water then feeds everything downstream: showers, laundry, the water heater, the ice maker. Most systems we fit pair a sediment prefilter with a tank of carbon media, which reduces chlorine taste and odor and catches grit before it reaches fixtures.
This setup makes sense when the problem shows up everywhere, not at one faucet: a chlorine smell in the bathroom, grit in the aerators, or water that looks different after a storm or a line repair. If drinking water is your only concern, a reverse osmosis system under the sink may be the better fit, and we will tell you that plainly.
Carbon filtration does not soften water. If a test shows meaningful hardness, we will talk through water softener installation or a salt-free water conditioner alongside it.
What the installation includes
- A water test first
- Before we recommend anything, we check chlorine, hardness, iron and sediment at your tap. Those numbers decide the media and the tank size.
- Sediment prefilter
- Water passes through a replaceable cartridge before it reaches the main tank, which holds back sand, grit and loose mineral particles. That keeps the carbon bed clean, and it is the piece you will replace most often.
- Carbon media tank
- A sealed tank of activated carbon, sized to how much water your home draws, so pressure stays steady when two showers run at the same time.
- Bypass valve and tidy plumbing
- A bypass valve sends water around the system when needed, so your home keeps running water while a cartridge is changed or the tank is serviced. Every joint is cut square, supported and labeled, and we clean up the work area before we leave.
- A walkthrough before we leave
- We show you where the bypass is, how the prefilter housing opens and when each part is due for a change.
When a whole-home system is worth a look
The bathroom smells like a pool
Warm shower water lets chlorine escape as vapor, so a steamy bathroom often gives it away before a glass of tap water does.
Grit in aerators and showerheads
Small particles collecting in screens point to sediment moving through your lines.
Cloudy or tinted water after a storm
Line breaks, pressure drops and flushing after heavy weather can stir up sediment. If it keeps happening, filtration at the main line catches it before it reaches fixtures.
Stains or film on fixtures
Spotting and residue can come from iron or hardness. A test tells us which, so you buy the right equipment.
Filters on every faucet
If you are maintaining pitcher filters, a fridge filter and a shower filter, one system at the main line is often simpler.
How the work goes
- 1
Phone call and free test
You call, we arrange a visit and test your water. You get the results and a plain recommendation, including when a system is not needed.
- 2
Written quote
We list the equipment, the media and anything the plumbing needs. Installation itself is free.
- 3
Installation day
We shut off water briefly, cut in the system with a bypass and lay down protection where we work. Most homes are without water only for part of the visit.
- 4
Flush and check
New carbon is flushed until the water runs clear. We check for leaks, confirm pressure and test again so you can see the difference.

What affects the price
Price depends on how much water your home uses and what the test finds. We quote by phone after the test, with each part listed so nothing appears later.
- Household size and flow
- More bathrooms and more people mean a larger tank and media volume to keep pressure steady.
- What needs removing
- Chlorine alone calls for a simpler setup than chlorine plus iron or heavy sediment.
- Where the line enters
- An accessible main line in a garage is straightforward. A cramped or exterior location may need extra fittings or a protective enclosure.
- Condition of existing plumbing
- Corroded valves or old fittings at the tie-in point are worth replacing while the water is off, and we price that separately.
Whole-home filtration questions
Something not covered here? (512) 710-0596
Is my shower going to lose pressure once the system is in?
A correctly sized system should leave your pressure where it was. When people notice a drop after an install, it usually traces back to a tank that is undersized for the house or a prefilter cartridge left in well past its change date. We size the tank around the busiest hour in your home, when showers and the washer overlap, and we show you how to spot a prefilter that is due.
Does it make water safe during a boil notice?
No. Carbon filtration improves taste and catches sediment, but it is not a substitute for following a boil-water notice. If you want added protection against microorganisms, ask us about UV water purification.
How often does the media need replacing?
Sediment cartridges usually need a change every few months, depending on how much your water carries. The carbon bed lasts far longer than that. We build a schedule from your test results and the number of people living in your home.
What warranty comes with the system?
We warrant the systems we install: lifetime warranty on tanks and ceramic discs, 5 years on the control valve, circuit board and filter media, and 1 year on labor. We walk through exactly what that covers when we go over your quote.
Do you serve homes outside Lockhart?
Yes. We also work in Luling, San Marcos, Kyle, Buda, Cedar Creek and Redwood. The free water test is handled the same way wherever you live.

Find out what is in your water first
A quick test shows whether whole-home filtration fits your home and which setup makes sense. You get the results and a written quote, with installation included at no charge.